Rear Wheel Bearings

Propcar50

Member
I've taken everything apart and removed the bearings. No problem. What concerns me is I took out more than I expected. Starting from the inside, I took out the grease seal, the inner bearing, 2 large washers, and the spacer. The outside had no surprises. I checked the parts book and saw no reference about the large washers. For that matter, it doesn't show the spacer either. Should I put everything back the way I found it? Thanks, Randy in Gaithersburg, MD
 
Been awhile since I've had that apart but I've found the parts manual blow-up drawings to be accurate. The large washers are described in the manual as spherical washers and the spacer as a distance bushing. Maybe I'm not understanding it but are those the parts in question? Amphicar.com technical section for members has the Parts Manual if you're not already referencing it. It's critical to get it right. Good luck.
 
Been awhile since I've had that apart but I've found the parts manual blow-up drawings to be accurate. The large washers are described in the manual as spherical washers and the spacer as a distance bushing. Maybe I'm not understanding it but are those the parts in question? Amphicar.com technical section for members has the Parts Manual if you're not already referencing it. It's critical to get it right. Good luck.
Duh, of the course, the technical library.
For what it's worth, Here's what I pulled out of the hub.
Starting on the left: inner grease seal, inner bearing, big washer, spacer, spacer, big washer, outer bearing, Snap clip, outer grease seal.
Does this look correct?
 

Attachments

  • rear bearings.webp
    rear bearings.webp
    60.4 KB · Views: 1
Duh, of the course, the technical library.
For what it's worth, Here's what I pulled out of the hub.
Starting on the left: inner grease seal, inner bearing, big washer, spacer, spacer, big washer, outer bearing, Snap clip, outer grease seal.
Does this look correct?
I found the correct page in the parts manual. All is good.
 
Sounds like you've got it sorted out. The cupped washers go together with the outer edges touching. Spacers go on both sides of the washers so the cupped washers get compressed by the spacers when the M20 castle nut is tightened.
 
Top