Jon March
Member
Sure, i did some 15/20 mph splash-ins during my debut Amphicar trials last month. The citizens insist on good times.
But now im home, and remembered - dry them quarters!
Some folks may remember I sanded, scraped, phosphoric acid etched, rinsed and then treated my rear quarter panels with Mastercoat oxygen-blocking, aluminum-silver MCU metal coating.
....As a last step, I filled the bottom weld-seal area of my quarter panels with 3M 5200, diluted with Acetone to make it pourable, and allowed it to flow&evel along the bottom of the v-cavity, to create a watertight, flat area down there. I think it will be a pretty tight seal and good surface treatment for that famously dark and mysterious place.
But how to really get the water that splashes down there, out? Paper towels are nicely absorbent, but they tear and its just a PITA stuffing them down with a flat ruler and trying to pick them out all tattered.
And them petcocks dont drain completely.
So i use my iphone in lights-on/ video pause mode, and a length of Tygon tubing on my mini shopvac, with the tip sanded into a taper , and just run that sucker up and down the valley!
Next experiment - run a piece of some kind of weighted?, closed cell foam "lodged" perforated hosing to stay down in those deep crevasses, with the other ends coiled up by the taillites, ready to attach to any shopvac. Sayyy...why not a tee fitting on the bilgepump, you say?
A: i dont think it would have the needed velocity to suck the area truly dry
J Swing
But now im home, and remembered - dry them quarters!
Some folks may remember I sanded, scraped, phosphoric acid etched, rinsed and then treated my rear quarter panels with Mastercoat oxygen-blocking, aluminum-silver MCU metal coating.
....As a last step, I filled the bottom weld-seal area of my quarter panels with 3M 5200, diluted with Acetone to make it pourable, and allowed it to flow&evel along the bottom of the v-cavity, to create a watertight, flat area down there. I think it will be a pretty tight seal and good surface treatment for that famously dark and mysterious place.
But how to really get the water that splashes down there, out? Paper towels are nicely absorbent, but they tear and its just a PITA stuffing them down with a flat ruler and trying to pick them out all tattered.
And them petcocks dont drain completely.
So i use my iphone in lights-on/ video pause mode, and a length of Tygon tubing on my mini shopvac, with the tip sanded into a taper , and just run that sucker up and down the valley!
Next experiment - run a piece of some kind of weighted?, closed cell foam "lodged" perforated hosing to stay down in those deep crevasses, with the other ends coiled up by the taillites, ready to attach to any shopvac. Sayyy...why not a tee fitting on the bilgepump, you say?
A: i dont think it would have the needed velocity to suck the area truly dry
J Swing
Last edited:




